Air compressor
cylinder.
Blocking without deformation.
Calibrated orifices made with templates.
Staple housing made with a flat chisel in order to shape the staple
to be set.
Fitting of the staple in the housing with pneumatic tools.
Screw fitting to ensure tightness.
Broken side with a linkage.
Fitting of a replacement insert.
Wire stapling, setting, finish.
An adapted solution to all your cast iron pieces: cold wire stapling
which consists in linking the two broken, cracked or separated pieces
by using
staples. This method gives back its strength to the original piece
without any deformation.
METAL’OCCITAN: HIGH STANDARD PROCESSES FOR BETTER SATISFACTION
!
THE DIFFERENT STAGES OF WIRE STAPLING
Calibrated orifices made with templates
Staple housing made with a flat chisel in order
to shape the staple to be set
Staple setting in the housing using pneumatic
tools
Screw settings for tightness seal
HARD
FACING AGAINST WEAR
Kneader
arm
Hard facing by DO 33 thread
Picking tines
Auger machine screws
Side hard facing
Unit construction hard facing
We use our knowledge to improve the mastering of your wear problems.
